Buffers

Colour

Metres/Ft

per spool

Metres/Ft

per bag

Cut lengths

‘D’ section (hollow)

Normally placed around the edges of the trolley (between corner buffers) to prevent damage to door jambs, etc.

Fitted by pushing a (off-cut) metal strip along the centre of the section and screwing through into the side of the trolley. The head of the screw will pop through the outer rubber leaving a small hole.

If the strip is to be fitted on a rounded corner, this should be of at least 50mm radius to prevent buckling of the strip.

D25

Pewter grey

80

262.4ft

8

26.24ft

as required up to

80 metrers

262.4ft

A premium is paid for ‘bag lots’ or ‘cut lengths’

Buffers - leg

Round PU

These are used to prevent damage to corridor walls. The buffers are placed onto tubular legs just before the castors. When a trolley approaches a wall the buffers make contact first and freely revolve on the tubing, thus rolling the trolley along the wall so it causes no damage.

In the case of 25.4mm (1”) square tubing the urethane buffers are supplied with a 38mm (11/2”) hole, together with a ‘dress-cap’ with a 25.4mm (1”) square inner and a 38mm (11/2”) round outer.

pewter grey

BU100X25

BU125X25

Pewter

grey

25.4mm

1” round

BU100X32

BU125X32

32mm

11/4” round

BU100X25SQ

BU125X25SQ

32mm

1” square

Dress cap - BUDC25

Black

32mm

1” square

Buffers - corner

TPE (Thermo-Plastic Elastomer)

Corner buffers can be fitted to new or existing trolleys with square corners. They stop much of the damage to walls, door jambs, etc.

They are fitted by four pan head self tappers, which are recessed down inside each arm of the buffer (No. 10x1” or similar).

Being made from TPE they are very resistant to abrasion, chemicals, etc.

The end profile is matched to the ‘D’ section rubber strip.

CB8025

Pewter

grey